Goodall Viper - Spinnaker Pole

Viper Owner's Manual 20
9. Undo the remaining trapeze wires and take the Stamasters apart.
3.2 Spinnaker Pole
Setting up the spinnaker pole is done after the mast has been raised.
1. Fit the spinnaker pole to the front beam
using the pin and retainer clip. The pole
must be supported by the bridle loop
while this is done.
2. Assure that the knots on both bow braces are the same length. Connect the front braces to
the bow by passing a loop through the hole in the bow and then pass the knotted tail
through the loop on the outside to prevent the loop coming back through. Work this firm so
it will not move during sailing.