2. Pass the retrieval line trough the eyelet in the
bottom of the chute and use the tiller
extension to pull it up and out by poking the
extension down and tying the line to it.
3. Tie the retrieval line the bridal until you are ready to attach the spinnaker.
4. Before racing you should be sure that the reinforced area of the halyard is in the cleat when the
spinnaker is hoisted, adjust this by shortening or lengthening the knot at the head of the spinnaker.
The reinforcement on the halyard is near the taper where the halyard feels extra thick.
3.3.3 TACK LINE
The tack line will be already threaded into your spinnaker pole for you. Once the pole is fully
attached to the boat the tack line maybe threaded as follows
To Next Page
Loading...