Goodall Viper - Before Raising the Mast; After Raising the Mast

Viper Owner's Manual 22
Running the halyards and organizing the spinnaker system is usually done before the mast is raised.
Setting up the pole and attaching the spinnaker is done after the mast has been raised.
3.3.1 BEFORE RAISING THE MAST
1. Take the tapered halyard and pass
the Dyneema end through the
hoisting cleat and up to the hoisting
block near the top of the mast
passing through any anti foul loops
on the way. Make sure the halyard
passes in front of all shroud wires
and on the port side of the forestay
at the hound fitting.
2. Take the Dyneema end and tie it to the mast spanner and cleat the other end into the
hoisting cleat, this will stop it falling out while raising the mast.
3.3.2 AFTER RAISING THE MAST
3.3.2.1 HALYARD
1. Pass the retrieval end through the beam
saddle, back to the take-up pulley on the
tramp. Pass it forward trough the retrieval
block and pass it through the hole in the
tramp.