1. Take the tack line from where it exits the spinnaker pole and pass it around the cheek block
on the bottom on the beam. Then, in this order, pass it trough the trip line thimble, the cam
cleat and the restraining saddle. This should all pass underneath all of the cunning ham lines.
2. Pass the line between the tramp and
hull to the turning pulley on the
outside of the beam and then pass it
through the eyelet in the tramp.
3. On the underside of the tramp, pass
the tack line trough the pulley on the
spinnaker retrieval shock cord and
finish by tying it off at starboard
righting rope saddle on the main
beam. These lines should pass on top
To Next Page
Loading...