3. Untie the retrieval from the bridal
and pass it through the first
retrieval point on the spinnaker
and tie it off at the top retrieval
point.
4. The spinnaker sheets are attached
by hitching the red connecting
loop in the middle of the
spinnaker sheet though the eyelet
in the clew of the spinnaker.
5. Take the port spinnaker sheet and
pass it inside the crew’s trapeze
wire and run it through the ratchet
on the deck. Then to the turning
block attached to the front beam.
6. The other end of the spin sheet
passes around the front of the
forestay and threaded through the
spinnaker blocks the same as the
other sheet. The tails of the
spinnaker sheet are then tied
together.
To Next Page
Loading...