Goodall Viper - Page 33

Viper Owner's Manual 33
Using the long Dyneema loop connect the clew of
the main sail to the boom and top mainsheet block.
Pass the Dyneema through the clew of the main
and top mainsheet block keeping the boom inside it
and loop the end over the stopper ball to lock it off.
Locate the loose end of the main sheet and tie it to
the loose end of the traveler line. Make sure the
stopper knot on the traveler line prevents the
traveler car from hitting the beam bolts at the ends
of the traveler track.
Connect the Cunningham to the sail. This consists of
2 single tack pulleys that go either side of the main
sail and a single pulley that is attached to a bracket
just above the base of the mast. Run the rope loop
from one of the clew pulleys through the clew eyelet
of the main sail and though the other clew pulley
and run the knotted end of the rope through the
rope loop.