Be sure to remove any twists in the
downhaul line and halyard. Attach the jib
halyard to the top webbing loop of the jib
and run both the fore stay and the halyard
in to the zip pocket.
Pull the halyard while holding onto the zip
runner. Stop when the Dyneema loop on
the halyard comes out. Loop the S hook
from the jib downhaul to the Dyneema
loop.
Pull the zip runner the remainder of the way
down and close the webbing with the press
stud.
Shackle the tack of the sail to the shackle on
the apex of the bridal.
Set the jib luff tension as required.
Shackle the jib sheet single pulley to the
clew of the jib. The middle hole will be best
for most conditions.
To Next Page
Loading...