Page 23
Programming the Fan (Setup Steps 35 - 38)
Fan Program (Setup Step 35) - This feature allows the fan to be programmed to turn
on automatically for a specified period during the day. If this feature is set to ON, the
next three steps will appear.
Minutes Of Fan Runtime Per Hour (Setup Step 36) - This setting specifies the num-
ber of minutes (0 - 60, in increments of 5) that the fan will run at the top of each hour.
Fan Program Start Time (Setup Step 37) - This setting specifies the hour of each day
when the programmable fan feature will start.
Fan Program Stop Time (Setup Step 38) - This setting specifies the hour of each day
when the programmable fan feature will stop. NOTE: Setting the Stop Hour equal to
the Start Hour will cause the fan to run 24 hours a day.
Installer Setup
This feature allows the user to increase the cooling or electric strip heating efficiency
of the system. The thermostat may be programmed to continue running the fan after a
call for cooling or electric strip heating has been satisfied. This delay can be set for 0,
30, 60, 90, or 120 seconds. If set to 0, the fan will not run after a call for cooling or
electric strip heating has been satisfied.
Fan Off Delay in Seconds (Setup Step 56)
This feature allows the thermostat to display temperature in Fahrenheit or Celsius.
Fahrenheit or Celsius (setup step 57)
Control To Temp Source (Setup Step 40)
This feature allows the user to specify which sensor source the thermostat
will use to measure room temperature. Thermostat: Uses the internal thermostat
sensor only. Remote Sensor: Uses wireless or wired sensors only. NOTE: If a remote
sensor is being used, the degree icon on the large room temperature display will blink.
temperature
This feature allows the user to choose if the wired sensor will be used as an indoor or
outdoor sensor.
Wired Sensor Use (setup step 39)
To Next Page
