3.1 Charging Your Cylinder Speaker
Quick Setup
Your cylinder speaker has a built in rechargeable battery so it can be used
anywhere indoors. Before using it for the first time please fully charge the battery.
When charging is completed, remove the USB cable and make sure that
the silicon cover is closed.
When the cylinder speaker is fully charged the RED LED indicator will turn off.
To charge, open the silicone control panel cover on the side of your cylinder
speaker.
Connect the USB cable provided to the USB port on your cylinder speaker.
Connect the other end of the USB cable to a USB port on your computer, or
a 5V 1A USB wall charger. A wall charger is not included. When your cylinder
speaker is charging the LED indicator will show RED.
Note: When the battery is getting low, the low battery warning alert will
sound, when you hear this, please recharge the battery.
To Next Page
Loading...
