To Next PageTo Next Page
Need help?Do you have a question about the GoodMeasure EDMI MK7A and is the answer not in the manual?
General| Brand | GoodMeasure |
|---|---|
| Model | EDMI MK7A |
| Category | Measuring Instruments |
| Language | English |
Instructions for setting up an Android phone as a Wi-Fi hotspot with specific SSID and password.
Steps to configure an iPhone as a Wi-Fi hotspot, including setting SSID and password.
Guide for setting up a dedicated mobile access point with required authentication and encryption.
Steps to remove the terminal cover and disconnect the existing modem cable.
Attaching the Integrator to the meter slot using an RJ45 interconnect cable.
Plugging the meter's modem cable into the right-hand end of the Integrator.
Guidance on using interface cables for external meters or sensors with correct polarity.
Activating the hotspot and ensuring the Integrator's power LED is steady red.
Interpreting the sequence of the Status LED for connection status.
The administrator's role in configuring Integrator settings via the service.
Navigating to the GoodMeasure website using a tablet or laptop.
Logging in using an authorized Google or Microsoft account.
Choosing an existing site or initiating the creation of a new site.
Providing name and location details for a new site.
Initiating the process to add a new gateway to the selected site.
Inputting the 16-digit serial number found on the Integrator.
Assigning a descriptive name to the Integrator for identification.
Navigating to the installation tab and selecting the specific Integrator.
Accessing network settings and viewing available Wi-Fi access points.
Selecting a Wi-Fi network and entering its password.
Activating the connection to the configured permanent Wi-Fi network.
Disabling the temporary Wi-Fi hotspot/tether used during setup.
Procedure for adding a new device to be monitored by the Integrator.
Choosing the device type and filling in required fields like serial and user ID.
Setting Port, Baud Rate, and Framing for device communication.
Assigning a descriptive name to the data channel for a connected device.
Navigating to the readings section and selecting the device channel.
Checking if the displayed data properties are accurate and meaningful.
Ensuring cables are tidy and trimming internal plastic rib if necessary.
Finalizing the installation by attaching and sealing the terminal cover.
Resolving problems with the status LED sequence or gateway connectivity.
Troubleshooting steps for when the system cannot read data from the EDMI meter.
Resolving issues with reading data from attached MODBUS RS485 devices.
