04 Connecting the Battery Enclosure to the Inverter
10
User Manual V1.2-2022-10-30
04
Connecting the Battery Enclosure to the Inverter
CAUTION!
The inverter should be powered down during this process.
The battery enclosure is now ready to be connected to the inverter mounted on the same wall
above the battery enclosure as per gure 13.
1. Connect the Amphenol connectors, on the top of the battery enclosure, to the matching
battery connectors at the base of the inverter.
Note: You need to check the inverter’s commissioning steps to complete the commissioning of the
whole system.
2. Connect the battery enclosure’s earth lead to the earth terminal inside the inverter.
3. (optional) Install the panels and wiring slot between the two battery enclosures. Connect
the cable connectors on the second battery enclosure to the inverter and the master battery
enclosure.
4. With the inverter’s BoS box and the battery enclosure’s front cover still open, turn on the
inverter and subsequently close the battery breaker in preparation for the commissioning
process.
To Next Page
Loading...