Figure 3-7
⚫ Step 2: Fix the inner rails on both sides of the chassis.
⚫ Step 3: Install the outer rail on the cabinet bracket and secure the screws.
Figure 3-8
Note: When installing the guide rail, you need to align with the U mark. When
you hear a snap, install it in place, and use M5 screws to fix it. solid.
⚫ Step 4: Align the chassis with the inner rails installed with the outer rails for
installation.
Note: When pushing the chassis forward, if you hear a clicking sound and
cannot continue pushing, you need to downwardly press the inner rail latch
to unlock it and then continue gently pushing the chassis.
⚫ Step 5: Once the chassis cannot slide forward, make sure that the screws are
securely tightened to complete the installation.
Note: During device maintenance, loosen the panel screws and gently pull the
chassis. Avoid forcefully accelerating the sliding of the chassis to prevent
damage to the equipment.
To Next Page
Loading...
