4.1 Initial Configuration
4.1.1 Power on the system
⚫ Before powering on, ensure that all server configurations are installed
according to the corresponding specifications and standards, and the
server is powered off but remains connected to the power source.
Additionally, ensure that all cables are properly connected, and the power
supply voltage matches the requirements of the equipment.
⚫ During the power-on process, please do not disconnect or plug in any hard
drives, power modules, network cables, or other external devices and cables.
⚫ If the server has just been unplugged from the power supply, please wait for 1
minute before turning on the power.
⚫ Server power-on power status:
When the power is connected but the server is not turned on, the power
indicator light will be yellow.
When the power is connected and the server is turned on and booting, the
power indicator light will be green.
⚫ Server power-on method:
The server is set to the "power on" boot policy by default, which means
that the server will automatically power on when the power is connected.
Users can modify this setting in the BIOS Setup interface.
⚫ During the boot process, press the <DEL> key on the keyboard to enter the
BIOS Setup interface. Locate the following interface:
Figure 4-1
To Next Page
Loading...
