⚫ After powering on the server, pay attention to the POST process during startup.
On the logo screen, in the lower left corner, the IP address is displayed.
⚫ After powering on the server, pay attention to the POST process. Press the
<DEL> key on the keyboard to enter the BIOS Setup interface and switch
to the following screen:
Figure 4-3
Configure IPV4 support: _
⚫ BMC sharelink Management Channel
⚫ Configuration address source
⚫ Configure the BMC IP address allocation mode, the menu options are:
Unspecified: Do not change the BMC parameters
Static: BIOS static IP setting
DynamicBmcDhcp: BMC is running DHCP for dynamic IP allocation.
DynamicBmcNonDhcp: BMC is running a non-DHCP protocol for dynamic IP
allocation.
Default value: Unspecified
After modifying from Unspecified to other parameters, saving and restarting, the option will
revert to the Unspecified value. There is no need to configure the BMC IP during every startup
process.
⚫ When the Configuration Address source option is set to Unspecified, the
network parameter information (IPv4) of the system's shared network port will
be displayed. This includes the current IP configuration mode, BMC IP, subnet
mask, MAC address, route IP, and route MAC.
⚫ BMC Dedicated Management Channel
⚫ Configuration address source
⚫ Configure the BMC IP address allocation mode, the menu options are:
To Next Page
Loading...
