GoRave AR5 - General Concepts; No Power; No Sound; Interrupted or Poor Quality Audio Playback

GORAVE AR5 AUDIO RECEIVER
Owner’s Installation and Operation Manual
V1.4 / 12-16-2014
12
5.3 No Sound
If the GoRave AR5 is powered on but not producing sound, check the LED indicator.
► If LED indicator is dim amber or dim green:
● The AR5 Audio Receiver is waiting to receive a signal from an Audio Sender.
● The GoRave AR5 Amplier / Receiver is looking for a new Audio Sender.
● Select and insert an Audio Sender into a device and play music.
● When you hear your audio, press and hold the Connect button for 3 seconds to save that Audio
Sender to the Favorites List. The LED status indicator will turn bright green.
● Use The GoRave App to conrm that the Audio Sender you are using is connected.
► Is the volume on the device set too low?
► Is your device on mute?
● Increase the volume on your device.
► Is your device further than 30 feet (9.1 meters) away?
● Bring the transmitting device closer to the AR5 Audio Receiver.
► Is another device transmitting at low volume from another Audio Sender?
● Disconnect the rst Audio Sender and start playback with the second.
● Press the Connect button 6 times to clear the Favorites List and reset volume settings in the AR5.
► Is the device with the Audio Sender turned on?
► Is audio actually playing on your device?
● Start playback of audio on your device.
► Do you have more than one AR5 Audio Receiver installed in your space?
● Is your audio playing from speakers connected to the other Audio Receiver?
● Does the GoRave app on your device show the Audio Receiver you want to play to?
If not, follow Section 3.3. to add your Audio Sender to the Favorites List for that AR5.
● The Audio Receiver may be receiving a signal from another Audio Sender at low volume or mute.
Stop audio playback from the other Audio Sender by disconnecting it from its device.
● Alternatively, press the Connect button 6 times to clear the Favorites List and reset volume settings
in the AR5.
5.4 Interrupted or Poor Quality Audio Playback
► Playback from a source connected to the AR5 via the wired auxiliary input will take priority over input
from wireless Audio Receivers.
► If the Auxiliary Input connection is wired to a cable, noise on the input line may cause the AR5 to drop
the Audio Sender playback in favor of the wired aux input.