GoRave AR5 - Playing Audio; Quick Start Guide; Connect Button and LED Status Indicator; Playing audio from a smartphone or tablet device

GORAVE AR5 AUDIO RECEIVER
Owner’s Installation and Operation Manual
V1.4 / 12-16-2014
7
3. Playing Audio
The GoRave AR5 has one wireless and one auxiliary wired input connection. The wireless connection accepts
input from one or more wireless GoRave Audio Senders. The auxiliary input enables you to play audio from
conventional audio sources – such as a CD player – on your GoRave loudspeakers.
3.1 Quick Start Guide
a) Insert a GoRave Audio Sender into your device. If you are using a 30-pin Apple device, (e.g. iPhone 4S)
install the GoRave app from the Apple iTunes Store.
b) Play some audio on your device.
c) Double-click the Connect button on the AR5. The LED status indicator should turn bright amber and you
will hear your audio play on the GoRave loudspeakers.
d) Press and hold the Connect button for 3 seconds to add your Audio Sender to the AR5’s Favorites List. The
LED will turn bright green.
e) Press the Connect button four times to put the AR5 into “All Play” mode. The LED will turn red.
For addional detail, read the following sections.
3.2 Connect Button and LED Status Indicator
Connect Button: Status: LED Indicator:
Single Click Playing or waiting to play from an Audio Sender on
the Favorite List.
(dim)
(bright)
= waiting
= playing
Double Click Playing or waiting to play from an Audio Sender
that has not yet been added to the Favorite List.
(dim)
(bright)
= waiting
= playing
Hold Add or remove an Audio Sender from the AR5
Favorite List by pressing and holding the connect
button for 4 seconds.
to = added Favorite
(ash) = deleted
4 Clicks *RECOMMENDED: Put the AR5 into “All Play”
mode to play from any Favorite Audio Sender with-
out manually pressing Connect button each time.
(dim)
(bright)
= waiting
= playing
6 Clicks Clear the Favorites List and reset volume settings. (ash) = list reset
3.3 Playing audio from a smartphone or tablet device
Go to http://gorave.com/support and select the “Audio Sender” guide for a quick video tutorial on this topic.
a) Insert a mobile GoRave Audio Sender into your smartphone or tablet device.
b) Open the GoRave app. (Note: the GoRave volume control app needs to be open (but can be minimized)
when you are using the 30-pin Audio Sender with a 30-pin Apple device. The rst time you connect a 30-pin
Audio Sender, you will automatically be taken to the iTunes Store to download the app for your device.)
c) Start playing audio on the device.