GoRave AR5 - LED Indicator Is Continuously Flashing (Fast Blink); Specifications

GORAVE AR5 AUDIO RECEIVER
Owner’s Installation and Operation Manual
V1.4 / 12-16-2014
13
● Increase the master volume on the device with the Audio Sender up to at least 50%.
● If the AR5 is not playing audio from an Aux input device, turn the input volume to at least 50%. This
will trigger the AR5 to stop playing the Audio Sender signal and start playing the Aux input signal.
► Crackle or static in the speakers may result from connection problem with Audio Sender. This can hap-
pen if you’re holding your device and pushing/moving the Audio Sender with your ngers.
► Unexpected pauses or drops in playback can result from the Audio Sender being out of range from the
Audio Receiver.
5.5 LED Indicator Is Continuously Flashing (Fast Blink)
The LED indicator will continuously ash with a fast, high frequency when one of these conditions is detected:
a) The GoRave AR5 was set to operate beyond its specications. To resolve the issue, try:
● Lowering the volume
● Reseating (remove then reconnect) the wireless Audio Sender
● Turn the power to the GoRave AR5 off then on.
b) The fault protection circuit has shut off the amplier. This occurs only when there is faulty speaker wiring,
or a problem with overheating. Unplug the system and wait for the amplier to cool. Correct the cause then
reconnect the power. The GoRave AR5 will reset. If the problem is not corrected or reoccurs, contact your
professional installer.
6. Specications
Continuous Power Output 20 watts per channel @ 8 Ω
Frequency Response 20 to 20 kHz
Speaker Impedance 4 to 16 ohms
Power Requirements 90-270 VAC 50/60Hz
Power Consumption Maximum 160 watts
Dimensions (WxHxD) 166 x 76 x 226 mm
Weight (net) 1.5 kg
All specications are accurate at the time of printing. Levven Electronics Ltd. reserves the right to make chang-
es and improvements to GoRave without notice.