Gorenje Classico BO73CLI - Page 33

425514
Removing wire guide racks
To facilitate cleaning of the oven interior side walls, the wire
guide rack can be removed.
• Hold the guide rack by its lower end and rotate it inwards;
then, remove them from the holes on the upper side.
• Clean the guide racks guides only with conventional
cleaners.
• After cleaning, simply re-hang the guide rack in the holes
provided and pull the downwards.
REMOVING INSIDE DOOR GLASS – APPLIES TO
PREMIUM FULL-GLASS DOOR
Door glass can also be cleaned from the interior side;
however, door has to be removed fi rst (see section on
removing and replacing the oven door).
• Slightly lift the supports on the left and right side of the
door (marking 1 on the support) and pull them away
from the glass (marking 2 on the support) (see Figure 1).
• Hold the door glass by the lower edge, slightly lift it so
that it is no longer attached to the support, and remove
it (Figure 2).
• To remove the third inside glass (only with some
models), lift and remove it. Also remove the rubbers on
the glass (Figure 3).
• To replace the door, observe the reverse order.
Note: To replace the glass, make sure the markings
(crescent) on the door and the glass are aligned
(Figure 4).
fi gure 1
1
2
fi gure 2
fi gure 3
fi gure 4
33