Gorilla Playsets Landing - Page 31

Step 2: Inserting T-Nuts Into Corner Posts
1: Use a hammer to seat the t-nuts after inserting them into the holes shown in the
diagram below.
2: The barrel of the t-nut should go in the hole rst. Hammer the t-nut until it is ush/
almost ush to the corner posts. No t-nuts will be installed in the Rear Corner Posts
where shown below.
No T-Nut in these holes
T-Nut
Corner Post # 3
(Rear - Left)
Corner Post # 2
(Front - Left)
Corner Post # 1
(Front - Right)
Corner Post # 4
(Rear - Right)
Page 31
®