Step 3: Sandbox And Panel Support Board
1: The 2 x 6 x 47-3/8” End Sandbox Board (with four pre-drilled holes) attaches to the
bottom of the Front Corner Posts, offset holes down with two 5/16” x 4-1/2” hex bolts
and two 5/16” washers.
2: The 2 x 4 x 47-3/8” Panel Support (with two pre-drilled holes) attaches to the front
side of the Front Corner Posts, offset holes down, with two 5/16” x 4-1/2” hex bolts and
two 5/16” washers.
5/16” Washer
2 x 4 x 47-3/8”
Panel Support
(offset holes
down)
2 x 6 x 47-3/8”
End Sandbox Board
(offset holes down)
5/16” Washer
5/16” x 4-1/2”
Hex Bolt
5/16” x 4-1/2”
Hex Bolt
Corner Post # 3
(Rear - Left)
Corner Post # 2
(Front - Left)
Corner Post # 1
(Front - Right)
Corner Post # 4
(Rear - Right)
Page 32
To Next Page
Loading...
