Step 16: Panel Boards
1: Place the 2 x 4 x 12” Bottom Panel Board - Left and 2 x 4 x 12” Bottom Panel Board
- Right on top of the 2 x 4 at the front of the play set as shown below with offset holes
down. Attach each Bottom Panel Board with one 5/16” x 3-1/2” lag screw and one 5/16”
washer.
2: Place the 2 x 4 x 47-3/8” Panel Support on top of the 2 x 4 at the rear of the play set
with offset holes down. Attach the Panel Support with two 5/16” x 3-1/2” lag screws and
two 5/16” washers.
.
2 x 4 x 12”
Bottom Panel
Board - Left
(offset
holes
down)
2 x 4 x 12”
Bottom Panel
Board - Right
(offset
holes
down)
2 x 4 x 47-3/8”
Panel Support
(offset holes down)
5/16” Washer
5/16” x 3-1/2”
Lag Screw
5/16” Washer
5/16” x 3-1/2”
Lag Screw
Page 45
To Next Page
Loading...
