Gosafe G2P - USP1;1 Command: Set Report Mode 1 (User 2); PRQ Command: Query Current Position

8
O = Disable position report.
<Parameter2>:
T = Position is shown in text.
W = Position is shown is hyper link.
Note: O is letter.
8.Command USP1;1
This command is to set report mode1 for user phone number#2
1234,USP1;1;30M;G;W
Tracker
Remark
User SMS
G2P V1.00
USP1:1;30M;G;W
BAT 60%
#1
USP1;1;<Report interval>;<Paramter1>;<Paramter2>
<Report interval>:
Range is from 30S to 900S, 15M to 59M, 1H to 720H.
S = Second
M = Minute
H = Hour
<Parameter1>:
G = GPS position preferred.
O = Disable position report.
<Parameter2>:
T = Position is shown in text.
W = Position is shown is hyper link.
Note: O is letter.
9.Command MEI
This command is to query GSM module IMEI of tracker, aka device ID.
1234,MEI
Tracker
User SMS
G2P V1.00
MEI:351535053999389
BAT 60%
#3
10.Command PRQ
This command is to query current position of tracker.
1234,PRQ
Tracker
User SMS
G2P V1.00
LTM 2013-06-06 14:17:12
http://maps.google.com/maps?q=23.164374,113.428576&t=m&z=16
SPD 0km/h 0
CSQ -52dBm
BAT 60%
#5
Note: Position information in message may vary depending on setting/current status.