Gosafe G2P - GFS Command: Define Geo-fence

11
18.Command BMC
This command is to set threshold percentage for battery low event.
1234,BMC;30
Tracker
Remark
User SMS
G2P V1.00
BMC:30
BAT 60%
#6
BMC;<Percentage>
<Percentage>:
Low than this value will switch to low voltage status
and trigger battery low event, range is from 5 to 99.
19.Command GFS
This command is to define a Geo fence.
1234,GFS;1;25.31;113.0;1000
Tracker
Remark
User SMS
G2P V1.00
GFS:1;25.31;113.0;1000
BAT 60%
#1
GFS;<Toggle>;<Latitude>;<Longitude>;<Radius>
<Toggle>:
0 = Disable Geo-fence.
1 = Enable Geo-fence.
<Latitude>:
Latitude of centre point of circular Geo fence,
In degree.
<Longitude>:
Longitude of centre point of circular Geo fence,
in degree
<Radius>:
Unit is meter, range from 100 to 1000000.
20.Command PSS
This command is to toggle power saving mode.
1234,PSS;1;3;2
Tracker
Remark
User SMS
G2P V1.00
PSS:1;3;2
BAT 60%
#6
PSS;<Toggle>;<Stop duration>;<Transmission idle duration>
<Toggle>:
0 = Disable power saving mode.
1 = Enable power saving mode.
<Stop duration>:
Device stops for such duration will switch to power saving
mode, unit is minute, range from 1 to 255.
<Transmission idle duration>
Device has not data transmission request for such duration
will switch to power saving mode, unit is minute, range from 1
to 255.