Gosafe G2P - User Commands; UNO0 Command: Set User Phone Number; UPW0 Command: Change Password; USP0;0 Command: Set Report Mode 0

6
7. User command
1.Command UNO0
This command is to set user phone number#1 that has authority to interact with tracker.
Example:
Phone number: 13800138000, country code: +86
1234,UNO0;+8613800138000
Tracker
User SMS
G2P V1.00
UNO0:+8613800138000
BAT 60%
#1
2.Command UPW0
This command is to change the default password 1234 for user phone number#1, 4 digits fixed.
1234,UPW0;5678
Tracker
User SMS
G2P V1.00
UPW0:5678
EXT_PWR=11.94V
BAT 60%
#2
3.Command USP0;0
This command is to set report mode0 for user phone number#1
1234,USP0;0;30S;G;W
Tracker
Remark
User SMS
G2P V1.00
USP0:0;30S;G;W
BAT 60%
#1
USP0;0;<Report interval>;<Paramter1>;<Paramter2>
<Report interval>:
Range is from 30S to 900S, 15M to 59M, 1H to 720H.
S = Second
M = Minute
H = Hour
<Parameter1>:
G = GPS position preferred.
O = Disable position report.
<Parameter2>:
T = Position is shown in text.
W = Position is shown is hyper link.
Note: O is letter.
4.Command USP0;1
This command is to set report mode1 for user phone number#1
1234,USP0;1;30M;G;W
Tracker
Remark
User SMS
G2P V1.00
USP0:1;30M;G;W
USP0;1;<Report interval>;<Paramter1>;<Paramter2>