GOSSEN Foto- und Lichtmesstechnik GmbH 17
2.8 Watch/Alarm clock
WATCH - Setting the time
Use the function button to select the function WATCH and hold the
key down until the OK-signal will sound. 12/24 will flash.
With the function button select either 12 hours (AM/PM) - 24 hour display.
Confirm with the function button. The read-out "hours" will flash.
Use the key M to set the hours and confirm with the function button.
The read-out "minutes" in the display will flash.
Use the key M for setting the minutes. To confirm settings hold down
the function button until the OK-signal is heard.
ALARM CLOCK
Use Function button to enter the function "ALARM CLOCK" and hold it
pressed down until the OK-signal will sound. The time of the alarm clock
is set in the same way as the watch.
Hold the Function button until the OK-signal sounds.
The alarm is activated or deactivated with the measuring button.
When the alarm is activated it is shown in the display with a bell symbol.
When the alarm is sounded it will sound each second for 1 min. It can
be stopped by pressing either the measuring key or the function button.
To Next Page
Loading...
