GOVECS FLEX - Ignition and Security; Remote Control Operation; GOVECS App Operation

14
IGNITION
Turning the scooter ON
• Get near the scooter and press the activation button on
the remote control
• The Start/Stop button will start flashing
• Press and hold the Start/Stop button for two seconds to
activate the scooter
• Make sure the side stand is folded so that parking mode
is not active
• The scooter is then ready to drive
Turning the scooter OFF
• Drive your scooter to a safe parking position
• Press the Start/Stop button firmly to put the scooter
system to sleep mode.
• Hold the handlebar firmly and get off the scooter
• Unfold the side stand (or the central stand)
• Turn the handlebar all the way to the left (the scooter is
equipped with an automatic steering lock that protects
the scooter from theft)
• Use your remote control’s switch off button to deactivate
the system (and lock the steering)
• The system will remain active until the steering lock is
properly secured.
• The Start/Stop button should go out
Turning the scooter ON
• Turn on Bluetooth connection on your device
• Get near the scooter and open your GOVECS APP to see the list
of all accessible scooters
• Select your scooter on the list
• Type in the six digit code that appears on your scooter display
• If pairing is successful, the Start/Stop button will start flashing
• Press and hold the Start/Stop button for two seconds to activate
the scooter
• Make sure the side stand is folded so that parking mode is not active
• The scooter is then ready to drive
Turning the scooter OFF
• Drive your scooter to a safe parking position
• P
ress the Start/Stop button firmly to put the scooter system to sleep mode.
• Hold the handlebar firmly and get off the scooter
• Unfold the side stand (or the central stand)
• Turn the handlebar all the way to the left (the scooter is equipped
with an automatic steering lock that protects the scooter from theft)
• Use your APP to deactivate the system (and lock the steering)
• The system will remain active until the steering lock is properly secured
• The Start/Stop button should go out
USING THE REMOTE CONTROL USING THE GOVECS APP