4. Pellet Stove installation
Deciding Where to Locate your Pellet Appliance and CLEARANCES TO COMBUSTIBLES:
When installing this unit on a combustible floor (for example linoleum, hardwood flooring) a
noncombustible hearth pad (15mm thickness) must be under the unit. The pad must extend at least
the width of the appliance [22‖ (558 mm)] and at least the depth of the appliance plus 6‖ (153 mm)
in front of the appliance [29 3⁄4‖ (756 mm)].
The clearance between the walls or to the top is no less than the
size of 50mm.
1. Electrical:
The unit must be grounded. The grounded electrical cord should be connected to a standard
230V, 50Hz (4.5 Amps), (115 volts (4.5 Amps), 60 hertz) electrical outlet. Be careful
that the electrical cord is not trapped under the appliance and that it is clear of any hot
surfaces or sharp edges and also must be accessible. If this power cord should become
damaged, a replacement power cord must be purchased from the manufacturer or a qualified
dealer.
2. Air input and venting pipe Installation
Several examples, taken by NB-P15, are the following
Horizontal and Up,
To Next Page
Loading...