5. Operation
1. The first ignition
When first time‘s running, the paint can be get rid of by burning. So some unpleasant Smell might
come out. Please open the window and door to vent the smell.
Note: If the new stove, when its first time using, it is necessary to put a handful of wood pellet to
the fire pot before hand.
Put wood pellet fuel into the hopper, connect the power. Then On/Off Light is Lighting (It means
that power is on). Operate as the instruction on section 2―start and operation‖
2. Start and operation
Please operate the stove as following (refer to stove structure figure and electrical control figure):
Check the box, pellet grate bar，air mate board and ash pan then adjust to proper position.
Push On/Off button UP to 3mins, the light is off and the combustion fan starts to work for 20
seconds to clean the fire pot, then feeding Light is On, meanwhile Convection Blower Lights and
Feel Intake Quantity Lights will be automatically selected to some level, ignitor is working as well.
After less than one Min‘s Feeding, it stops for a while, some smoke will come out, meanwhile, the
combustion fan starts. After Less than one min., it forms the stable flame.
Note: If the new stove, when its first time using, it is necessary to put some pellet to the fire
pot before hand.
Depending on the heating desire, fuel intake quantity can be adjusted from few to large by the fuel
intake Button. At the same time adjust the convention Button to blow the heat to the room to
reach the best combustion. (According to the various quality of wood pellet, please select right
feeding speed, in order to burn properly)
To Next Page
Loading...
