Spraying
16 3A4749D
Spray Tip Orientation
Adjust the Spray Tip Guard for the desired
vertical or horizontal spraying direction.
Spray Pattern Quality
A good spray pattern is evenly distributed
without voids or runs. Adjust sprayer Speed
Control, hand speed, and distance from the
wall to get a good spray pattern.
If tails persist, material may need to be
thinned. If material needs to be thinned,
follow manufacturers recommendations.
Spray Angle
Use a piece of scrap cardboard to practice
these basic spraying techniques before you
begin spraying the surface.
• Hold sprayer 10-12 inches (25-30 cm)
from surface and aim straight at surface.
Tilting the sprayer to direct the spray
angle causes an uneven finish.
To avoid serious injury from skin injection,
do not put your hand in front of the Spray
Tip or Spray Tip Guard.
NO YES
To Next Page
Loading...
