311209W
EN
Operations and Parts
Hot Melt
Dispense Guns
For use with Graco Therm-O-Flow
®
and Warm Melt Supply Systems for dispensing
non-flammable hot melt thermoplastic sealants and adhesives. For professional use only.
Not approved for use in explosive atmospheres or hazardous (classified) locations.
Maximum Working Pressure 5000 psi (34.5 MPa, 345 bar)
See page 2 for model information.
Important Safety Instructions
Read all warnings and instructions in this
manual before using the equipment.
Save these instructions.
Bottom feed model
Top feed model
To Next Page
Need help?
General
