What to do if the pump is frozen or paint hardened in my Graco Paint Sprayer?
If you're having basic mechanical problems with your Graco Paint Sprayer, such as a pump frozen or paint hardened in the pump, thaw the sprayer if water or water-based paint has frozen inside by placing it in a warm area until completely thawed. Do not start the sprayer until it is fully thawed. If paint has hardened (dried) inside, replace the pump packings.
How to fix loose motor leads on my Graco 309674M Paint Sprayer?
If you're facing basic electrical problems with your Graco Paint Sprayer's motor leads, replace any loose terminals by crimping them to the leads, ensuring they are firmly connected. Clean the circuit board terminals and securely reconnect the leads.
How to fix the displacement pump connecting rod pin on my Graco Paint Sprayer?
If you're dealing with basic mechanical problems on your Graco Paint Sprayer and the displacement pump connecting rod pin isn't fully pushed into the connecting rod, push the pin into place and secure it with the spring retainer.
What to do if my Graco Paint Sprayer stops after a few minutes due to a tight pump packing nut?
If your Graco Paint Sprayer quits after operating for 5 to 10 minutes, and you suspect the tightness of the pump packing nut, loosen the packing nut and check for leaking around the throat. Replace the pump packings if necessary.
General| Model | 309674M |
|---|---|
| Category | Paint Sprayer |
| Type | Airless |
| Maximum Pressure | 3000 PSI |
| Horsepower | 0.75 HP |
| Voltage | 120V |
| Amp Draw | 12 Amps |
| Hose Length | 50 ft |
| Tip Size | 0.015 in |
| Fluid Outlet Size | 1/4 in |
| Spray Pattern Width | 12 in |
| Fluid Inlet Size | 1/4 in |
To Next Page