Graco A Series Instructions-Parts List

POSITIONING THE GUN ARM ASSEMBLY
Setup for spraying arcs 3. mend the carriage bar (4) or second gun bar (404)
1. Disengage the trigger cable (1) and engage the gun
so you can easily watch the line you are painting and
also to avoid running overthe paint line. See page 18.
4.
Adjust the vertical and horizontal position of !he gun.
trigger safety latch.
See page 22.
2. Loosen the post clamp (58) and swing the arm (A)
back near the rear tire. Loosen the clamp (SA) and PO- 5, spray the arc from the o,&ide,
sition the arm (A)
so the tip guard aligns with the back
axle of the unit. Retighten the clamp.
Flg 19-1
ADJUST SIMULTANEOUS GUN TRIGGERING
rwAI*ING-l
To reduce the risk of a fluid Injection injury, always
disengage the trigger cable to the gun@) and en-
gage the guns' trigger safety latch before moving or
adjusting the guns or gun arms.
3.
-
1. Align the front of the guns by adjusting the gun arms.
2. Position the dual gun selector to trigger both guns.
See page 18.
See page 21.
Stalt the sprayer, using water, or spray on cardboard.
at the same time and place.
See page 14. Triggerthe guns to see if the lines begin
cable tension of the
gun that triggers
first.
See Adlust
If one
Pun trlaaers
before
Me other
aun,
reduce the
the trlgger cable tension on page 22
p, adjust the posl-
!ion of the guns. See page 18.
Trigger the guns to recheck the adjustments.
308-105 19

Graco A Series Specifications

General

Brand	Graco
Model	A Series
Category	Water Pump
Language	English