70
Sliding Latch Plate and ALR Retractor
A latchplate that slides freely on the belt
webbing and cannot, by itself, hold the belt
snug around a car seat.
Slowly pull the shoulder belt all the way
out. Route the vehicle seat belt through the
proper belt path and buckle it in. Then, as
you pull the vehicle seat belt tight, feed all
the slack back into the retractor.
Grab the sides of the seat at the belt path
and slide the seat side-to-side and front-to-
back. The seat should not move more than
1” (2.5 cm).
To Next Page
Loading...
