Table
of Contents
Warnings 2.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Introduction 5
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation 6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operation 10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Troubleshooting
Chart
12.
. . . . . . . . . . . . . . . . . . . . . . . .
Service 14
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts
Drawing
26.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts
List
27.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Technical
Data
28.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Dimensions
and Mounting Hole Layout
29.
. . . . . . . . . .
Performance
Charts
30.
. . . . . . . . . . . . . . . . . . . . . . . . . .
Graco
Standard W
arranty 32.
. . . . . . . . . . . . . . . . . . . . .
Graco
Phone Number
32.
. . . . . . . . . . . . . . . . . . . . . . . . .
Symbols
Warning Symbol
WARNING
This
symbol alerts you to the possibility of serious
injury or death if you do not follow the instructions.
Caution Symbol
CAUTION
This
symbol alerts you to the possibility of damage to
or destruction of equipment if you do not follow the
instructions.
WARNING
EQUIPMENT MISUSE HAZARD
Equipment
misuse can cause the equipment to rupture or malfunction and result in serious injury
.
D
This equipment is for professional use only
.
D
Read all instruction manuals, tags, and labels before operating the equipment.
D
Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor
.
D
Do not alter or modify this equipment.
D
Check equipment daily
. Repair or replace worn or damaged parts immediately
.
D
Do not exceed the maximum working pressure stated on the equipment or in the
T
echnical Data
for your equipment. Do not exceed the maximum working pressure of the lowest rated component
in your system.
D
Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the
Tech-
nical Data
section of all equipment manuals. Read the fluid and solvent manufacturer
’
s warnings.
D
Handle hoses carefully
. Do not pull on hoses to move equipment.
D
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose
Graco hoses to temperatures above 66
_
C (150
_
F) or below –40
_
C (–40
_F).
D W
ear hearing protection when operating this equipment.
D
Do not move or lift pressurized equipment.
D
Comply with all applicable local, state, and national fire, electrical, and safety regulations.
D
These pumps are designed to be used only in pumping non-corrosive and non-abrasive lubricants
and greases. Any other use of the pump can cause unsafe operating conditions and component
rupture, which can result in fluid injection or other serious injury
, or fire or explosion.
To Next Page
Loading...
Need help?
General
