Startup
332156E 9
Startup
1. Place suction tube and drain tube in grounded metal
pail partially filled with flushing fluid. Attach ground
wire to pail and to ground wire to earth ground.
2. Rotate handle counter-clockwise to open prime
valve.
3. Loosen lock nut and turn pressure control counter-
clockwise to lowest pressure.
4. Set pump valve OFF.
5. Start engine.
a. Move fuel valve to open.
b. Move choke to closed.
c. Set throttle to fast.
d. For electric start models: Rotate key to start.
For pull-start models: Set engine switch to
ON. Pull starter rope or turn ignition key.
Hydraulic system and engine may become very hot
during operation and could burn skin if touched.
Flammable materials spilled on hot, bare motor could
cause fire or explosion. Have belt guard in place
during operation to reduce risk of pinching or loss of
fingers.
ti7120b
ti21061a
ti7111b
ti7108a
To Next Page
Loading...
Need help?
General
