Setup
3A6400A 15
Setup
1.
All sprayers except ProContractor:
Connect
appropriate Graco high-pressure hose to sprayer.
2.
Select Units:
Install whip hose to fluid inlet of spray
gun and tighten securely.
3. Engage gun trigger lock.
4. When spraying texture, remove inlet strainer and
filter bowl screen when spraying materials.
5. Fill throat packing nut with TSL to prevent
premature packing wear. Do this each time you
spray.
6. Check engine oil level. Add SAE 10W-30 (summer)
or 5W-20 (winter), if necessary.
7. Fill fuel tank.
8. Attach sprayer grounding clamp to earth ground.
To Next Page
Loading...
