Start Up
3A3212C 15
b. Place drain tube in waste pail.
c. Submerge suction tube in a pail
partially filled with water or flushing
fluid.
Hopper Models
a. Lift drain tube with retainer off the
hopper.
b. While holding the drain tube retainer
with drain tube parallel to the top of
a waste pail twist retainer over the
lip of the pail. Drain tube should now
be inside the waste pail.
c. Pour approximately two quarts (two
liters) of water or flushing fluid into
the hopper.
3. Place Prime/Spray valve in PRIME
position.
4. Plug power supply cord into a properly
grounded electrical outlet.
ti27125a
65
t
27
ti27268a
To Next Page
Loading...
