Graco GX series - Power Flush

Cleanup
24 3A3212C
16. Turn ON/OFF switch to OFF position.
17. Clean filter. See Cleaning Insta-
Clean
™
Fluid Filter, page 28.
18. Fill unit with Pump Armor
™
fluid. See
Storage, page 29.
Power Flush
(GX 21, Water-based materials Only)
Power flushing is a faster method of flushing.
It can only be used after spraying
water-based coatings.
1. Perform Pressure Relief Procedure,
page 13.
2. Remove spray tip and tip guard assem-
bly from gun and place in waste pail.
3. Place empty waste and paint pails side
by side.
4. Lift suction tube and drain tube from
paint pail. Let paint drain into the pail.
5. Place suction and drain tube in waste
pail.
6. Turn Pressure Control knob to the
Prime/Clean setting.
7. Screw power flush attachment valve to
garden hose. Close valve.
8. Turn on water. Open valve. Rinse paint
off suction tube, drain tube and inlet
strainer then close valve.
ti27232a
ti27153a
ti27135a
7
1
55a
t
i
2
7
ti27156a