Cleanup
26 3A3212C
19. Place Prime/Spray valve in PRIME
position.
20. Turn ON/OFF switch to OFF position.
Hopper Flushing
(Hopper Models Only)
See Cleaning Fluid Compatibility, page 30.
1. Perform Pressure Relief Procedure,
page 13.
2. Pour any remaining material out of the
hopper.
3. Remove tip guard and Spray Tip. For
additional information, see Clean the
Gun, page 28.
4. Remove drain tube from paint hopper,
wipe excess paint off outside.
5. Place drain tube in waste pail.
6. Pour flushing fluid into the hopper. Use
water for water-based paint and mineral
spirits for oil-based paint.
7. Turn pressure control knob to the
Prime/Clean setting.
8. Turn ON/OFF switch to ON position.
ti25197a
65
ti27
ti27268a
ti27135a
To Next Page
Loading...
