Setup
3A4980B 9
Setup
Fluid and Work Piece
Preparation
• Strain fluids before spraying. This
includes colors, reducers and
hardeners.
• Use a slower drying reducer or thinner to
compensate for the faster drying time
caused by the warm air of the turbine. Do
not over reduce.
• Spray performance varies with the
viscosity of the material sprayed, HVLP
sprayer, and length of hose.
• Most material manufacturers provide
recommendations for their materials.
Follow these recommendations.
• For proper adhesion, ensure surface of
work piece is completely clean.
Fluid Set Selection
For best spray performance, select proper
fluid set for fluid being sprayed. Reference
the Fluid Set Selection Guide for the fluid
set recommended for your application. Fluid
set numbers are marked on fluid needles and
nozzles.
To Next Page
Loading...
Need help?
General
