Installation
313431A 9
3. To reposition roller support arm to any other position
than the Ship Position (AA or EE):
• HR & HP Model Reels
a. Secure spool against pedestal with C-Clamp.
b. Remove 4 nuts (b) and rotate arm to desired
position, BB, CC, DD, EE, or FF.
c. Check pawl to make sure it is not wedged. See
F
IG. 4.
• HS Model Reels
a. Secure spool against pedestal with C-Clamp.
b. Remove 8 nuts (b) and 2 bolts (c) to rotate
arm to desired position, AA, BB, CC, DD, or
FF.
c. Check pawl to make sure it is not wedged. See
F
IG. 4.
Overhead Installations
1. For HS Model Reels only, reposition guide arm to
position AA. See Step 3 for HS Model Reels
(above).
2. Position the hose reel so the pedestal is facing up.
3. Using the lift truck, raise the reel as close to the
mounting location as possible.
4. Bolt hose reel to its mounting. Be sure it is secure
before lowering the lift truck.
To reduce the risk of injury, when you are mounting a
hose reel overhead, always use a lift truck.
F
IG. 4
Incorrect
Correct
To Next Page
Loading...
