Gun Placement
3A3388A Operation 15
Gun Placement
Install Guns
1. Insert guns into gun holder. Tighten clamps.
Position Gun
2. Position gun: up/down, forward/reverse, left/right.
See Gun Positions Chart, page 17 for examples.
NOTE: When striping above a curb, the mounting clamp
can be rotated for clearance.
Another option can be to swing the gun out at an angle
and rotate the tip guard. This results in better visibility
for the user.
Select Guns (Standard Series)
3. Connect gun cables to left or right gun selector
plates.
a. One gun: Disconnect one gun selector plate
from trigger.
b. Both guns simultaneously: Adjust both gun
selector plates to the same position.
c. Solid-skip and skip-solid: Adjust solid-line gun
to position 1 and skip-line to position 2.
ti27780a
To Next Page
Loading...
