LineLazer V LiveLook Display
3A3388A Operation 47
Data Logging
The LLV control is equipped with Data Logging, which
allows the user to recall job data.
1. Press the to open the Data Logging pop up
window.
2. Choose to start recording a new job, view the J-Log,
erase the J-Log, or take a time stamp.
3. On the main striping screen, if the user resets the
data with a new job is automatically started.
Start recording a new job.
Erase the entire J-Log
User requested time stamp for the J-Log.
Gallons/liters of line painted
Gallons/liters of stencil painted
Total gallons/liters
J-Log is a constant data recorder that will take a time
stamp and show the data since the previous time
stamp. Time stamps occur at the following intervals:
• Every time the machine is turned on
• Every hour of constant run time
• When the user manually takes a time stamp
• When line width changes and paint is sprayed
• When a new job is started
When the J-Log is 90% full, the user will be notified. If the
J-Log is 100% full, Data Logging stops until the user
clears the J-Log.
ti28063a
LINE STCL TOT
AL
jO
XX
XX
XX
XX
XX
XX
XX
XXXX
START RECORDING NEW JOB
VIEW J-LOG
ERASE J-LOG
TIME STAMP
EXIT
A
B
C
E
0001 26.12.2015 1:00 300 12 1.1 0.0 1.1
0001 26.12.2015 2:00 100 14 0.7 2.0 2.7
0001 26.12.2015 3:00 400 15 3.0 1.0 4.5
0002 26.12.2015 5:00 0 15 0.0 4.0 4.0
0002 26.12.2015 6:00 1100 14 3.9 1.0 4.9
0002 26.12.2015 7:00 100 14 0.3 0.0 0.3
0003 26.12.2015 9:30 700 15 2.3 0.5 2.8
0003 26.12.2015 10:00 1200 12 4.1 1.0 5.1
JOB DATE TIME feet mil
â
To Next Page
Loading...
