LineLazer V LiveLook Display
40 3A3388A Operation
Stall Calculator
Stall Calculator is used to set the stall size. The striper
divides the measured length by the stall size to deter-
mine the number of stalls that will fit in the length mea-
sured. User can adjust number of stalls to a round
number and stall width is calculated.
1. Use to select Layout Mode. Press to
open Stall Calculator Menu.
2. The most recent length measured in Measure Mode
is automatically displayed. Press gun trigger control
to start a new measurement. Press again to stop
measuring.
Stall size and calculated number of stalls are both
adjustable.
3. Press to return to Layout Mode. The Stall size
is saved and displayed on the Layout Mode screen.
4. Press and release gun trigger control to start mark-
ing dots. Press and release gun trigger control again
to stop.
Ref. Description
1 Opens Angle Calculator Menu.
See Angle Calculator, page 41.
2 Exits and returns stall size to Layout Mode.
3 Measured distance.
4 Calculated # of stalls. Changing the number of
stalls will change the stall size.
5 Adjusts number of stalls.
6 Stall size. Changing stall size changes the calcu-
lated # of stalls.
7 Adjusts stall size.
8 Press to start measurement, Press to stop mea-
surement.
ti27917a
90.00’
9.00’
10.00’
10.00’
To Next Page
Loading...
