309414 13
Pressure Control
Control Board
Removal
1.
Relieve pressure; page 4.
2. Fig. 6. Remove four screws (93) and
display/cover (139). Pull display connector wings
open on PC board and pull display connector out.
3. Fig. 14. Disconnect at control board (109):
D Lead (D) from potentiometer.
D Lead (E) from transducer .
D Remove ON/OFF switch (24) connector (A).
4. Fig. 6. Remove six screws (214) from control board
(109) and green ground wire.
5. Remove two connectors (Y) at backside of pres-
sure control. Remove jam nuts (Z) and control
board (109).
Installation
When installing replacement control board, follow
instructions with control board to set model type.
1. Fig. 6. Install control board (109) and jam nuts (Z).
Install two connectors (Y) at backside of pressure
control.
2. Install green ground wire and control board (109)
with six screws (214).
3. Fig. 14. Connect to control board (109):
D Connect ON/OFF switch (24) connector (A).
D Lead (E) to transducer.
D Lead (D) to potentiometer .
4. Fig. 6. Push display connector into PC board close
display connector wings on PC board. Install
display/cover (139) with four screws (93).
Pressure Control Transducer
Removal
1.
Relieve pressure; page 4.
2. Fig. 6. Remove four screws (93) and
display/cover (139).
3. Disconnect lead (E) from control board (109).
4. Remove two screws (201) that connect control
housing (108) to filter housing (200e). From inside
of control box, pull transducer connector through
control housing (108).
5. Remove pressure control transducer (200p) and
o-ring (200r) from filter housing (200e).
Installation
1. Fig. 6. Install o-ring (200r) and pressure control
transducer (200p) in filter housing (200e). Torque
to 30--36 ft-lb.
2. Install transducer cable through control box. Install
filter housing and spacer to control box with two
screws (201).
3. Connect lead (E) to motor control board (109).
4. Install display/cover (139) with four screws (93).
Pressure Adjust Potentio meter
Removal
1.
Relieve pressure; page 4.
2. Fig. 6. Remove four screws (93) and
display/cover (139).
3. Disconnect lead (D) from control board (109).
4. Loosen set screws on potentiometer knob (19) and
remove knob, shaft nut, lockwasher and pressure
adjust potentiometer (81).
5. Remove seal (148) from potentiometer (81).
Installation
1. Install seal (148) on potentiometer (81).
2. Fig. 6. Install pressure adjust potentiometer (81),
shaft nut, lockwasher and potentiometer knob (19).
a. T urn potentiometer shaft (81) clockwise to
internal stop. Assemble potentiometer knob
(19) to strike pin on plate (23).
b. After adjustment of step a., tighten both set
screws in knob 1/4 to 3/8 turn after contact
with shaft.
3. Connect lead (D) to control board (109).
4. Install display/cover (139) with four screws (93).
To Next Page
Loading...
