Operation
3A4203B 25
11. Engage trigger lock.
12. Turn pressure control knob to the lowest
pressure setting and turn ON/OFF
switch to OFF position. Disconnect
power to sprayer.
13. Remove filter from gun and sprayer if
installed. Clean and inspect. Install filter.
See separate gun manual.
14. If flushing with water, flush again with
mineral spirits or Pump Conditioner to
leave a protective coating to prevent
freezing or corrosion.
15. Wipe sprayer, hose and gun with a rag
soaked in water or mineral spirits.
ti29541a
ti29545a
ti29644a
To Next Page
Loading...
