Install Automatic Upgrade Kit 15V256
312778G 39
Install the Discrete I/O Board
Install the Discrete I/O board (1) in the position shown in
F
IG. 26, using the four board supports (2) supplied in the
kit. See F
IG. 27 for board orientation.
Install the I/O Terminal Strips
1. Install the supplied din rail to the left of the power
supply (PS) as shown in F
IG. 26, using two 6-32 x
1/4 in. (6 mm) machine screws supplied with the
wire harness (5).
2. The supplied wire harness has one 28 in. (711 mm)
cable with a 10-pin terminal strip, one 28 in. (711
mm) cable with a 6-pin terminal strip, and a 3 ft
(0.92 m) CAT 5 cable.
a. Install the 6-pin terminal strip (6T) and 10-pin
terminal strip (10T) on the din rail. See F
IG. 26.
b. Connect the CAT 5 cable to J1 on the I/O board.
c. Route the wire harness cables through the wire
channel of the EasyKey to the display board
(C).
d. Connect the CAT 5 cable to J6 on the display
board.
e. Connect the 6-pin cable to J10 on the display
board.
f. Connect the 10-pin cable to J5 on the display
board.
3. See the System Electrical Schematic on page 44
for complete board wiring information.
4. Close and lock the EasyKey door.
To Next Page
Loading...
Need help?
General
