Operation
10 3A5411J
Take Measurement - New
Profile
Refill the Tank
After a tank is refilled from an oil distributor or
a waste oil tank is emptied by a waste oil
service provider, press the display button (A)
(F
IG. 7) on the TLM to ensure that the TLM will
maintain the most current tank volume status.
If the display button is not pushed, the TLM
will automatically read correctly at the next
scheduled tank reading.
Daylight Savings Time
(DST) Change
The Pulse software automatically adjusts the
time when daylight savings time changes
occur (Spring and Fall).
NOTE: The first TLM reading will be one hour
earlier or later (depending on the season,
Spring or Fall time change). All subsequent
TLM readings will be accurate.
FIG. 9: *NOTE: TLM will take a measurement
after a new profile has been loaded
To Next Page
Loading...
