Spraying
16 3A9301C
Spraying
Take a few moments prior to spraying and
review these simple tips to ensure your
spraying project is a success.
NOTE: For proper spraying operation use
only Graco FFLP family of tips with your
Spray Gun.
Flow Control
The Flow Control allows for precise pressure
adjustment. To reduce overspray, always
start at lowest speed setting and increase
speed to the minimum setting that results in
an acceptable spray pattern.
Tip and Pressure Selection
See table for recommended spray pressure for your material. Refer to paint (material) can for
manufacturer’s recommendations.
Spray Tip Orientation
1. Engage the Trigger Lock.
2. Adjust the Spray Tip Guard for the
desired vertical or horizontal spraying
direction.
Coatings
Interior
Stains/
Interior &
Exterior
Clears
Exterior
Solid Stains Enamels Primers
Interior
Latex
Paints
Exterior
Latex
Paints
Flow Control 1 – 4 4 – 8 4 – 10 6 – 10 6 – 10 6 – 10
Tip hole Size
0.008 in. (0.20 mm) ✓
0.010 in. (0.25 mm) ✓ ✓
0.012 in. (0.30 mm) ✓ ✓
0.014 in. (0.36 mm) ✓ ✓ ✓ ✓
0.016 in. (0.41 mm) ✓ ✓ ✓ ✓
To avoid serious injury from skin injection,
do not put your hand in front of the Spray
Tip or Spray Tip Guard.
To Next Page
Loading...
