Cleanup
22 3A9301C
Cleanup
See Cleaning Fluid Compatibility, page 26
and Grounding Instructions, page 10 for
additional information when using oil-based
or flammable materials.
Cleaning Sprayer
1. Engage Trigger Lock.
2. Turn Prime Knob up to PRIME position
to relieve system pressure.
3. Remove sprayer from the Belt by
pressing the Holster Release Clip and
pulling up on the sprayer.
NOTICE
Failure to properly clean sprayer after each
use will result in hardened materials,
damage to the sprayer, and the warranty
will no longer be valid. Do not store solvents
other than mineral spirits in sprayer. Always
flush with Graco Pump Armor prior to
storage.
To avoid serious injury from fire and
explosion when using oil-based or
flammable materials:
• Do not spray solvents through the
spray tip. Always remove tip guard and
spray tip before flushing. Clean tip
guard and spray tip in a bucket of
compatible solvent.
• Clean in a well-ventilated area. Keep a
good supply of fresh air moving
through the area.
• When flushing with solvents, always
ground the sprayer and waste
container.
The sprayer and
spray gun are
both equipped
with a static wick
that reduces the
build-up of static
charge to reduce
the risk of fire and
explosion. KEEP
THIS SURFACE
CLEAN OF
OVERSPRAY.
To Next Page
Loading...
